 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Model RFP-400-50T Flanged Terminations 400 Watts, 50 Flanged Terminations General Specifications Resistive Element: Substrate: Cover: Mounting Flange: Lead(s): Thick film Beryllium oxide ceramic Alumina ceramic Copper, nickel plated per QQ-N-290 99.99% pure silver (.005" thk) Features * DC - 500 MHz * 400 Watts * BeO Ceramic * Welded Silver Leads * Non-Nichrome Resistive Element * Low VSWR * 100% Tested Electrical Specifications Resistance Value: Frequency Range: Power: V.S.W.R.: 50 ohms, 5% DC - 500 MHz 400 Watts 1.30:1 Notes: Tolerance is .010, unless otherwise specified. Operating temperature is -55C to +150C (see chart). Designed to meet or exceed applicable portions of MIL-E-5400. All dimensions are in inches. Lead length 0.15" minimum. Specifications subject to change without notice. Outline Drawing .200 MAX. .125 .550 1.100 .250 .170 DIA. THRU. (2 PLACES) .500 RFP 400-50 T .250 .150 .800 VER. 12/5/01 Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369 .166 1 Model RFP-400-50T % OF RATED POWER Flanged Terminations 2 Typical Performance Power Derating Suggested Mounting Procedures .025 MIN. (2 PLACES) 100 75 50 25 0 25 50 75 100 125 150 BOARD LOWER THAN LEAD. BOARD EVEN WITH LEAD. BOARD LOWER THAN LEAD. BOARD HIGHER THAN LEAD. SUGGESTED STRESS RELIEF METHODS SCALE: NOT RECOMMENDED APPLICATION SCALE: 1. Make sure that the devices are mounted on flat surfaces (.001" under the device) to optimize the heat transfer. 2. Drill & tap the heatsink for the appropriate thread size to be used. 3. Coat heatsink with a minimum amount of high quality silicone grease (.001" max. thickness). 4. Position device on mounting surface and secure using socket head screws, flat & split washers. Torque screws to the appropriate value. Make sure that the device is flat against the heatsink. (Care should be taken to avoid upward pressure of the leads towards the lid). 5. Solder leads in place using an SN63 type solder with a controlled temperature iron (210C). CASE TEMPERATURE -- C Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369 |
Price & Availability of RFP-400-50T
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |